Denon AVR-5805 Instruções de Operação descarregar pdf (Página 127)

127

Note on playing a source encoded with DTS

• Noise may be generated at the beginning of playback and

while searching during DTS playback in the AUTO mode. If

so, play in the DTS mode.

Example: Stereo

Select the play mode.

(Main unit) (Remote control unit)

Start playback on the selected component.

• For operating instructions, refer to the component’s

manual.

Adjust the volume.

(Main unit) (Remote control unit)

The volume can be adjusted within the range of –80 to +18 dB, in

steps of 0.5 dB. However, when the channel level is set as

described on pages 51, 52 or 134, 135, if the volume for any

channel is set at +0.5 dB or greater, the volume cannot be adjusted

up to 18 dB. (In this case the maximum volume adjustment range

is “18 dB — (Maximum value of channel level)”.)

Input mode when playing DTS sources

• Noise will be output if DTS-compatible CDs or LDs are played in the

“ANALOG” or “PCM” mode.

When playing DTS-compatible sources, be sure to connect the

source component to the digital input jacks (OPTICAL/COAXIAL)

and set the input mode to “DTS”.

(Remote control unit)

M.VOL. -80.0dB

The volume level is displayed on the master volume level display.

Input mode display

• In the AUTO mode

• In the DIGITAL PCM mode

• In the DIGITAL DTS mode

• In the ANALOG mode

Depending on the input signal.

Input signal display

• DOLBY DIGITAL

• DTS

• PCM

The indicator lights when digital signals are being input

properly. If the indicator does not light, check whether the

digital input component setup (pages 58, 59) and connections are

correct and whether the component’s power is turned on.

AL24 processing is activated when PCM signals are played while

the surround mode is set to PURE DIRECT, DIRECT, STEREO,

MULTI CH DIRECT or MULTI CH IN.

Advanced AL24 processing is activated when PCM (2-channel)

signals are played while the surround mode is set to PURE DIRECT

or DIRECT.

DIG.

NOTE:

• The indicator will light when playing CD-ROMs

containing data other than audio signals, but no sound will be

heard.

DIG.

• In the EXT.IN mode

Depending on the input signal.

• The indicator lights when digital signals are

being input with a player that supports HDCD

playback.

HDCD

Depending on the input signal.

• The indicator lights when the DENON LINK

have been connected and the DSD signals have

been inputted. (See page 18)

DSD

The mode switches as shown below each time the

DIRECT/STEREO button on the Main unit is pressed.

STEREODIRECT

1 2 ... 122 123 124 125 126 127 128 129 130 131 132 ... 207 208

Comentários a estes Manuais

Sem comentários

Denon AVR-5805 Instruções de Operação Página 127

Comentários a estes Manuais

Manuais e produtos relacionados com Recetores AV Denon AVR-5805