
Easy Setup and Operation
POWER
ON/STANDBY
SPEAKERA
SETUP MIC
ON/SOURCE
MODEI-,,_J
-CURSOR
c_.--SPEAKER
The Auto Setup function of this unit performs an analysis of the
a
speaker system to permit an appropriate automatic setting, l uonneCting microphone
• Measurement and setting details _ Connect the microphone for Auto Setup to the
L:This sets the speaker connection, polarity, and bass / SETUP MIC jack u. the truat paae] uf t]ze unit.
reproduction ability.
,: This sets the delay time from each speaker corresponding to - ° . o _ e
the listening position. O _ o e e e _ _@_e_ _ _ e
t3::This sets the volume that is output from each speaker. '_ [.__]
For accurate measurements
• Keep quiet during the auto setup procedure. It is recommended
that you turn off the power of any air-conditioner, projector or
other equipment that may produce noise.
• De not stand between the microphone and speakers while
Auto Setup is performed.
• Do not place any obstacles between the microphone and
speakers. Also, be sure te point the speakers tewards the
listening position.
NOTE:
• A loud test tone is output during the measurement. Please
consider this should you be planning night time
measurements, and consider not allowing small children
into the listening room at this time.
• The Aute Setup is not displayed when "MUTING",
"HEADPHONE ONLY" is selected.
©
Place the microphone for Auto Setup at the actual
listening position which will be at the same height
as your ears.
"_ Place tne mlcroDnone on a mooo or level surface.
Easy Setup and Operation
Turn on your subwoofel:
Turn on your monitor (TV).
Press the POWER switch.
J= ON:
The oovder turns on ancI t"e inolcaTor ic qTS
Set the POWERsNItcn to tnls oos [ion to turn rne oower on
ana off from the included remote comro UnIT
! OFF:
The oo Jer turns off ano tne nalcator is off.
_-m,s oosmon, tne Dower cannot De Turnea on an(] off from
tne remote ConTrol unE
Press the 0N/STANDBY switch on the main unit
or 0N/SOURCE button on the remote conn-ol
unit.
" Tuln Oil the Jowel
Press the SPEAKERA button to turn the speakers
On.
Set the MODE 1 switch to "AUDIO" (only when
operating with the remote control unit).
8
I ENGLISH I
Comentários a estes Manuais