Denon AVR-686 Instruções de Operação descarregar pdf (Página 5)

Getting Started

Check that the following parts are included in addition te the main unit:

'_1}Operating instructions ............................ 1

_2};Wa rranty ................................................. 1

_3}}Service station list .................................. 1

'_4}Remote centrel unit (RC-1001) ............... 1

'_5}R6P/AA batteries .................................... 2

_6}AM leep antenna .................................... 1

_7.','FM indeer antenna ................................. 1

'_8_Omnidirectional micrephone ................... 1

Pay attentien te the fellewing before using this • Store these instructions in a safe place.

unit:

• Moving the unit

Te prevent short-circuits er damaged wires in •

the connectien cables, always unplug the power

supply cord and disconnect the connection

cables between all other audio cemponents

when moving the unit.

• Before turning the power switch on

Check once again that all cennectiens are

correct and that there are not preblems with

the cennectien cables. Always set the power

switch to the standby pesitien befere

cennecting and discennecting connectien

cables.

After reading, stere this instructions along with

the warranty card in a safe place.

Note that the illustrations in these

instructions may differ from the actual unit

for explanation purposes.

V. AUX terminals

The AVR-686's front panel is equipped with V.

AUX terminals. Remove the cap cevering the

terminals when yeu want te use them.

°O °

O @ @ O @ @ @

Getting Started

Noise or disturbance of the picture may be

generated if this unit er any ether electrenic

equipment using microprocessers is used

near a tuner or TV.

If this happens, take the fellowing steps:

• Install this unit as far away as possible

from the tuner er TV.

• Run the antenna wires from the tuner or

TV away from this unit's power supply cord

and input/eutput connection cables.

• Noise or disturbance tends to occur

particularly when using indeor antennas or

300 _/ohm feeder wires. We recommend

using outdoor antennas and 75 _/ohm

coaxial cables,

Note:

i N

For heat dispersal, do not install this unit in a confined space such as a bookcase or similar

enclosure,

• Switching the input source when input terminals are not connected,

A clicking noise may be produced if the input source is switched when nething is connected to

the input terminals. If this happens, either turn down the MASTER VOLUME control knob or

cennect cempenents to the input terminals.

• Muting of PRE OUT terminals, PHONES jack and SPEAKER terminals.

The PRE OUT terminals, PHONES jack and SPEAKER terminals include a muting circuit. Because

ef this, the output signals are greatly attenuated fer several seconds after the power switch is

turned on or the input seurce, surround mode or any ether set-up is changed. If the volume is

turned up during this time, the eutput will be very high after the muting circuit stops functioning.

Always wait until the muting circuit turns eff before adjusting the w>lume.

• Whenever the power switch is in the STANDBY state, the unit is still connected to AC line

voltage.

Please be sure to turn off the power switch or unplug the cord when you leave home for,

say, a vacation,

The included remote control unit (RC-1001 ) can be used to operate not only the AVR-686 but other

remete control compatible DENON components as well. In additien, the memory contains control

signals fer other remote control units, se it can be used te eperate nen-DENON remote centrel

compatible products.

I ENGLISH I

1 2 3 4 5 6 7 8 9 10 ... 60 61

Comentários a estes Manuais

Sem comentários

Denon AVR-686 Instruções de Operação Página 5

Comentários a estes Manuais

Manuais e produtos relacionados com Recetores AV Denon AVR-686