Denon AVR-882 Instruções de Operação descarregar pdf (Página 47)

r_ TROUBLESHOOTING

If a problem should arise,first check the following.

1. Are the connections correct ?

2. Have you operated the receiver according to the Operating Instructions ?

3. Are the speakers, turntable and other components operating property ?

If this unit is not operating properly, check the items listed in the table below. Should the problem persist, there may be a malfunction.

Disconnect the power immediately and contact your store of purchase.

o-o

Symptom Cause Measures Page

• Power cord not plugged in securely. • Check the insertion of the power cord plug. 9

DISPLAY not lit and sound not produced • Turn the power off with the remote control 25

when power switch set to on. unit after turning the POWER operation

switch on.

DISPLAY lit but sound not produced.

DISPLAY not displayed and the

"ON/STANDBY" LED flashes at a high

rate

Sound produced only from one channel.

Positions of instruments reversed during

stereo playback.

This unit does not operate properly when

remote control unit is used.

• Speaker cords not securely connected.

• Improper position of the audio function

button.

• Volume control set to minimum.

• MUTING is on.

• Digital signals not input Digital input

selected.

• Speaker terminals are short-circuited.

• Block the ventilation holes of the set.

• The unit is operating at continuous high

power conditions and/or inadequate

ventilation.

• Incomplete connection of speaker cords.

• Incomplete connection of input/output

cords.

• Reverse connections of left and right

speakers or left and right input/output

cords.

• Batteries dead.

• Remote control unit too far from this unit.

• Obstacle between this unit and remote

control unit.

• Different button is being pressed.

• _) and _ ends of battery inserted in reverse.

• Connect securely.

• Set to a suitable position.

• Turn volume up to suitable level.

• Switch off MUTING.

• Input digital signals or select input jacks to

which digital signals are being input.

• Switch power off, connect speakers

properly, then switch power back on.

• Turn off the set's power, then ventilate it

well to cool it down.

Once the set is cooled down, turn the

power back on.

• Turn off the set's power, then ventilate it

well to cool it down.

Once the set is cooled down, turn the

power back on.

• Connect securely.

• Check left and right connections.

• Replace with new batteries.

• Move closer.

• Remove obstacle.

• Press the proper button.

• Insert batteries properly.

14, 15

5,15

14, 15

9~14

Note:

When a subwoofer has been connected and the virtual surround function is being used, the signal played from the subwoofer channel is LFE

only (only when playing Dolby Digital or DTS signals) for initial factory settings (i.e., the setting of the front speaker is "LARGE" and the setting

of the subwoofer mode is "NORM").

When subwoofer effects are felt to be weak, while in the system setup mode try setting the subwoofer mode to "+MAIN", or the front speaker

to "SMALL" in the Speaker Configuration settings.

Making these settings will result in the low-frequency sounds of the front channel being played from the subwoofer.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 95 96

Comentários a estes Manuais

Sem comentários

Denon AVR-882 Instruções de Operação Página 47

Comentários a estes Manuais

Manuais e produtos relacionados com Recetores AV Denon AVR-882